InterForm Manual - System & Method

Activate ‘Conditional repositioning’ to reposition the grid when designing conditioned
suboverlays.
Press this icon to enable a background image, that previously have been
included in the designer via ‘Setup’, ‘Background image’ and ‘Select
background image’.
Press this icon to (temporarily) disable the grid and the rulers. This will make it
possible to place elements freely without the corsor is snapping to the grid.
Designing for colour or B/W (For laser/pdf overlays only)
You can shift between looking at the B/W output or colour output by pressing
this icon in the upper toolbar.
This will affect what you see in the graphical design and when you preview the
result in SwiftView and Acrobat Reader.
Designing for 203 or 300 DPI (For Zebra overlays only)
The printed ZPL result depends on if you run a 203 or 300 dpi printer.
Click this icon to change the resolution view, so that it fits that of the printer.
Debugging the design
Press this icon to temporarily disable all design elements below the marked
design element. This can be used e.g. to solve problems with conditions, that
does not execute as you thought.
Disabling/enabling the spooled file
Press this icon to (temporarily) disconnect/connect the spooled file and view
the overlay without any spooled file text.
Flipping through the pages of the spooled file
On the right side of the tool bar you will see this:
InterForm A/S 515