InterForm Manual - System & Method

AFC and OSC Commands
The End Auto Forms Control Job Command
The APF3812/ENDAFCJOB command can be used for ending a specific Auto Forms Control
job. The job can either be stopped immediately or controlled. This command can be used in
conjunction with the APF3812/STRAFCJOB command.
The Start Auto Forms Control Job Command
The APF3812/STRAFCJOB command can be used for starting one specific Auto Forms
Control job. Using this command it is e.g. possible to schedule a CL-program calling this
command in order to start merging and printing at a giving time.
Remember, in order for the job to become active, it is necessary that the AUTO_FORM
subsystem is active. Refer to page 129.
The Start OSC Job Command
The APF3812/STROSCJOB command is equivalent to choosing option 1 = Run OSC for a
specific output queue, on the Work with OSC definitions screen (see page 278).
Remember, that in order for the job to become active it is necessary, that the OSCCTL
subsystem is active. Refer to page 272.
440 User’s Manual for InterForm400 ®