GMC-SG001E-EN-P-JUN01 Motion Control Selection Guide

Motors 6-3
F-Series Motors
F-Series motors are commonly used when applications require
higher inertia-matching capability. Typical applications include
web and film processing, machine tool/metal cutting, textile
machinery, or cam replacements.
Each servo motor features:
• Compact design that is mechanically interchangeable with the H-Series family.
• Continuous torque from 3.5 to 28 N-m (31 to 245 lb-in.).
• Speeds up to 4000 RPM.
• Ferrite permanent magnet rotors that provide approximately four times greater rotor inertia than the
H-Series family for matching larger load inertias.
• Internal thermal switch to indicate overheating.
• Motor-mounted 2000-line optical encoder featuring quadrature output of 8000 pulses per revolution.
• Water-tight MS connections compatible with standard cable assemblies, and extruded aluminum
housing that provide an IP65 rating when the optional shaft seal is installed.
• Economical, compact design ready for harsh environments.
• Optional spring-set holding brakes available with 24V DC.
• Axially-trapped front bearing in a steel insert for long life at high speeds.
• UL listed.
Note: For drive compatibility, refer to the Motor Selection Chart in Preface.
Publication GMC-SG001E-EN-P — June 2001