GMC-SG001E-EN-P-JUN01 Motion Control Selection Guide

1394 Drive System Family 4-15
Figure 4.9
1394 Axis Module Front View Dimensions (1394x-AM50, -AM50-IH, -AM75, and -AM75-IH)
37.5
(1.48)
8 (0.32)
Dimensions are in millimeters and (inches).
Depth = 280 (11.02)
Mounting Hole Detail
8 (0.31)
10.1 (0.4)
400
(15.75)
350
(13.78)
385
(15.16)
Fastener
Location 1
15.9 (0.63)
8 (0.31)
12 (0.47)
All slots accept M6 or 1/4-20 Mtg. screws.
1 Dimension shown is for mounting hardware location
and does not reflect the location of the lower slot
radius.
75
(2.95)
75
(2.95)
Figure 4.10
1394 Axis Module Side View Dimensions(1394x-AM50 and -AM75)
385
(15.16)
280
(11.02)
Dimensions are in millimeters
and (inches).
Heat sink width only
338.1
(13.31)
105
(4.13)
43.69
(1.72)
Important: Additional clearance below
the axis is necessary to allow for the
recommended cable bend radius.
Publication GMC-SG001E-EN-P — June 2001