GMC-SG001E-EN-P-JUN01 Motion Control Selection Guide

8-60 Motion Control Accessories
1326AB Motor Feedback Mounting Adapters for 1394 Family
The following section contains configuration diagrams and catalog numbers for the feedback mounting
adapters available for 1326AB servo motors.
IMPORTANT
These adapters are not available for high-resolution feedback (-M2, -Ml, and -S2) motors.
IMPORTANT
Motors with IP65 or IP67 protection lose their rating when this option is used.
Figure 8.63
1326AB Servo Motor Encoder Mounting Adapter (1326AB-MOD-Mxx)
Servo Clamp
845H Mounting
Gasket
(remove and discard)
Faston Type
Connector
Access to Coupling
Coupling
845H
Encoder
1326AB Motor
Adapter
82.6 mm (3.25 in.) Maximum for All Motors
Note: Use servo clamps to mount an 845H servo mount encoder to the adapter plate.
Note: Coupling accommodates 9.53 mm (0.375 in.) encoder shaft.
Note: Servo clamps accommodate both English and metric servo encoder mounting configurations.
ATTENTION
!
To avoid equipment damage caused by the gasket after adapter installation, remove
and discard gasket during disassembly.
Publication GMC-SG001E-EN-P — June 2001