Tsunami - Beckman Institute Laser Resource Center
Tsunami - Beckman Institute Laser Resource Center
Tsunami - Beckman Institute Laser Resource Center
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
I1 I1 I I I iil I miin II I l I Lllll lli U il Ill i i ill I1 I I I UQ I I I I<br />
Alignment<br />
-<br />
Requirements for Conversion<br />
I<br />
To convert <strong>Tsunami</strong> from fs to ps operation requires the following:<br />
Changing output coupler Mlo.<br />
Removing the tuning slit and adding the appropriate bi-fi into the<br />
cavity.<br />
Moving Prl and Pr4 out of the beam path.<br />
Replacing the high reflector at M1 with the GTI.<br />
To convert from ps to fs operation, simply reverse this procedure.<br />
NOTE<br />
When changing between fs and ps measurements, the scan range of the<br />
Spectra-Physics <strong>Laser</strong>s Model 409 autocorrelator must be modified in<br />
order to accommodate for the large change in pulse width. Consult your<br />
autocorrelator manual for this procedure.<br />
Fs to ps Conversion<br />
Verify the <strong>Tsunami</strong> laser is lasing prior to beginning this procedure, and<br />
maximize its output power.<br />
1. Close the pump laser shutter.<br />
2. For safety, turn off the Model 3955 electronics module.<br />
3. Remove the high reflector assembly.<br />
a. Loosen the three screws holding the high reflector mounting ring<br />
in the rear mirror plate, and turn the three D-shaped cam locks so<br />
the flat portion of the cam disengages the mounting ring. The<br />
high reflector assembly is removed in a manner similar to that for<br />
the GTI shown in Figure 6-17.<br />
b. Pull the high reflector assembly with its mounting ring from the<br />
rear mirror plate and store it in a safe place.<br />
4. Install the GTI (Figure 6- 17).<br />
Refer to chapter 5, "Installation: Installing the GTI."<br />
5. Turn on the Model 3955 and allow about 20 minutes for the GTI and<br />
AOM to warm up.<br />
You may continue with the installation while you wait for the heaters<br />
to warm up.<br />
6. Open the shutter, and re-establish lasing.<br />
a. Place a white card in front of mirror M5.