Tsunami - Beckman Institute Laser Resource Center
Tsunami - Beckman Institute Laser Resource Center
Tsunami - Beckman Institute Laser Resource Center
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Tsunami</strong><br />
Setting up the Routing Mirrors<br />
Use the two routing mirrors provided to route the pump beam to the<br />
<strong>Tsunami</strong> laser as shown in Figure 5-1 and Figure 5-2, then install the<br />
dust tubes as shown in Figure 5-2.<br />
1. Loosen the height adjustment setscrew on each routing mirror assembly<br />
and slide the mirror body from the base mount.<br />
2. Find the two table mounting holes that align the mirrors with the two<br />
lasers and, using the single captive screw in the base of each mirror<br />
assembly, fasten the bases to the table using these holes.<br />
One hole should be in the row of holes on which the BearnLok laser<br />
output window was centered, the other in the row on which the<br />
<strong>Tsunami</strong> input window was centered. The holes should be about 20<br />
cm from their respective windows and must be in the same row with<br />
each other.<br />
3. Slide the mirror body back into the base mount, leaving the setscrew<br />
loose.<br />
r<br />
Slide this dust tube over the BeamLok<br />
pump laser output snout.<br />
Insert this dust tube into the <strong>Tsunami</strong><br />
laser input bezel.<br />
7.62 cm (3 in.) Long<br />
14 cm (5.5 in.) Long 15.25 cm (6 in.) Long<br />
15.25 cm (6 in.) Long 7.65 cm (3 in.) Long<br />
15.25 cm (6 in.) Long<br />
cover to clean mirror.<br />
Setscrew to lock<br />
height adjustment.<br />
Mirror Base Mount<br />
Table Mounting Screw (Inside Base)<br />
Figure 5-2: Routing Mirror Setup<br />
5-4
Change language