9600 Service Manual - gmecorp-usa.com

Event Codes & Messages (Cont.)
22 ANODE IS HOT E, N Anode temperature is at approximately
80% of its rated heat capacity.
23 N/A N/A N/A
24 HOUSING
OVERHEATED
E, F Housing temperature is at 100% of its
rated value and the thermal cutoff switch
has activated open.
25 WILL OVERHEAT E, N The tube anode or housing is at 80% of
its rated heat capacity. Continued use in
FILM mode, without allowing the tube to
cool may damage the tube. You must
wait for the tube to cool before the next
FILM exposure is allowed, or select a
sufficiently lower technique. The display
will also present the message WAIT.
26 N/A N/A N/A
27 NO BOOST - HOT E, N The X-ray tube anode or housing is at
80% of its rated heat capacity. Continued
use in fluoro boost, without cooling, may
damage the tube. When displayed, the
BOOST ENABLE LED turns off.