9600 Service Manual - gmecorp-usa.com

32 Generator Calibration
19. Without powering off the system, copy the MALIMIT.DAT file from the SRAM to the
generator backup software diskette as follows:
A. Power on laptop. Select AMICARDZ icon in Windows.
B. Remove necessary covers to access the Technique Processor PCB
C. Remove the SRAM from the Technique Processor PCB.
D. Insert SRAM into PCMCIA slot.
E. After the message "Card Inserted in Socket 1" appears, select OK.
F. Exit to DOS and go to the F:\ drive.
G. Insert backup generator diskette in the floppy.
H. Enter the command "COPY MALIMIT.DAT A:"
I. Replace the SRAM in the Technique Processor
J. Remove the floppy diskette.
20. This completes the 5R Entrance Exposure Calibration procedure.