9600 Service Manual - gmecorp-usa.com

4 Peripherals
RECORD UNPROCESSED VIDEO (VCR 1
To record to the VCR:
1. Insert an S-VHS tape cassette into the recorder.
2. Position the tape to the starting point for the recording. Press VCR Play to review
the tape if necessary to determine the index number of the new starting point. Reset
the index counter or make note of the index reading.
3. Press the VCR RECORD key. The recorder LED is lit. Press the SUPERKEY to
start or stop processing images.
4. Proceed with the desired surgical procedure. The recorder records images
whenever the X-ray On switch or Process Fluoro footswitch is pressed. The VCR
automatically goes to PAUSE when the footswitch is released.
NOTE: During the recording process, the monitor displays the processed image. The
image recorded on the tape, however, depends on the VCR configuration. The
default configuration is unprocessed video, that is, undigitized video output. Refer
to Configuring VCR Options later in this section.
5. Record the tape index counter reading when the recording session is completed.
REVIEW THE RECORDING
To review the video recording:
1. Load the recorded S-VHS cassette into the recorder.
2. Position the tape at the start of the recording with the recorder’s positioning keys
(REV, PLAY and FORWARD).
3. Press VCR Play on the TrackPad panel. The LED is lit.
4. Press the SuperKey to start or stop processing images.