9600 Service Manual - gmecorp-usa.com

viii 9600 Imaging Workstation Service Manual
COMPONENT LOCATIONS
IMAGE FUNCTION PCB
The image function PCB, pn 878400, is located in the card rack assembly
on a 12-inch system; it is not located under the camera cover next to the
image intensifier as in older systems. For procedures that require
accessing the image function board (for example, camera cooler
verification), follow the steps below.
ACCESSING AND REMOVING IMAGE FUNCTION PCB
1. Switch off the main power.
2. Remove the rear cover assembly. (Refer to the “Cover Removal”
section in the System Overview chapter, 9600 System Service
Manual.)
3. (a) Remove the 4 screws on the card rack cover, then (b) remove the
card rack cover (see Figure 2A next page).
NOTE: The call-out numbers on Figures 2A and 2B correspond to the
same-numbered steps here.
4. (a) Grasp the image function board’s ejector levers and pull them
outward to unlock, then (b) pull the PCB out of the card rack (it should
unplug from the motherboard and slide out from the snap guides).
See Figure 2B.
5. To re-install, make sure the PCB’s ejector levers are in the open
position, align the PCB in the snap guides, then perform the above
steps in reverse order.