9600 Service Manual - gmecorp-usa.com

16 Mechanical Assemblies
CONTROL PANEL HOUSING REMOVAL
The Control Panel Housing must be removed before the Wig Wag Assembly can
be accessed.
WARNING... Electrical circuits inside the equipment use voltages that are capable
of causing serious injury or death from electrical shock. Use
appropriate precautions.
1. Turn the Workstation keyswitch to the OFF position.
2. Remove the Hole Plug and 1 Torx screw securing the Cross Arm Brake
Handle.
3. Remove 2 Torx screws from the bottom of the Cross Arm Lower Cover.
4. Lift the Cross Arm Center Cover up carefully and unplug switch wiring on the
Control Panel Processor PCB and the Distribution PCB.
5. Remove 4 Torx screws securing the Cross Arm Lower Cover and lower the
cover so that the Wig Wag Assembly can be accessed.
6. Remove the Hole Plug from the bottom of the Wig Wag brake handle and
loosen the screw.
7. Remove the Wig Wag brake handle.
8. Remove 2 flathead Allen screws in the bottom of the retaining plate and
remove the retaining plate.
9. Loosen the set screw.
10. Turn the actuator screw clockwise using a standard slotted screwdriver until
the brake assembly can be removed.