9600 Service Manual - gmecorp-usa.com

Peripherals 5
CUSTOMIZE VCR OPTIONS
The Customize function on the Workstation function panel is used to change VCR
options. The reasons to change options are:
• During the recording process, the processed image is displayed on the monitor, but
the image recorded on the tape depends on the configuration (processed or
unprocessed).
• Typically, only one recorder is connected to the system. However, it is possible to
record simultaneously on two video recorders, one for processed video and the
other for unprocessed video.
To set the recording formats for VCR 1/VCR 2:
1. Press the CUSTOMIZE key and select VCR RECORD in the menu bar. The
Configure VCR Option menu, as shown in Figure 3, is displayed. The default
recording setup is Unprocessed for VCR 1 and Processed for VCR 2.
EXIT SAVE
CONFIGURE VCR OPTION
VCR 1
UNPROCESSED
PROCESSED
VCR 2
UNPROCESSED
PROCESSED
FLUORO ONLY
UNPROCESSED
PROCESSED
Figure 3 - Menu to Customize VCR Configuration
2. Use the TRACKPAD or Arrow Keys to highlight the desired processing mode for
VCR 1 and press the SUPERKEY or ENTER key to change the selection. The box
next to the selected option will be filled. Repeat for VCR 2 if desired.
3. Save the selection by highlighting SAVE on the menu bar and pressing the
SUPERKEY or ENTER. Exit the program by selecting EXIT from the menu bar.