9600 Service Manual - gmecorp-usa.com

9600 Imaging Workstation Service Manual xix
CCD CAMERA REMOVAL
To remove the CCD camera, perform steps 1 - 7 of the previous “II Power
Supply Removal” section (p. 10) to access the camera, then refer to the
“CCD Camera Replacement” section in the Image System chapter, 9600
System Service Manual.
COLLIMATOR REMOVAL
Collimator removal and replacement procedures are identical to those of
the 9-inch system. Refer to the “Collimator Replacement” section in the
Image System chapter, 9600 System Service Manual.
X-RAY TUBE REMOVAL
X-ray tube removal and replacement procedures are identical to those of
the 9-inch system. Refer to the “Replacement of the X-ray Tube” section in
the Image System chapter, 9600 System Service Manual.
BEAM ALIGNMENT
Follow the procedures in “Beam Alignment” in the Image System
Calibration chapter (9600 System Service Manual), but note the
following different components for the 12-inch system. Refer also to Figure
8 (next page) for the beam alignment tool.
TOOLS
• Beam alignment tool, OEC P/N 00-878867-01
(includes 12-inch alignment grid, p/n 00-878862-01)
• (QTY of 3) 1mm copper plates, OEC P/N 00-877682-02
• Film Cassette Holder Asm., 12-inch, OEC P/N 00-878820-01
• Bore sight alignment tool, 12-inch, OEC P/N 00-877589-02