9600 Service Manual - gmecorp-usa.com

28 Workstation Control
INTERCONNECT CABLE
The interconnect cable connects the C-Arm to the Workstation. The Workstation end of
the cable is hardwired to the Aux Interface PCB and power distribution connectors within
the Workstation. The C-Arm end has a plug that connects to a mating receptacle on the
power panel of the C-Arm. Matching red dots on the plug and the receptacle are used
for connector alignment when plugging the cable to the C-Arm.
CAUTION: Exercise care when handling the interconnect cable connector to avoid
dropping it on a hard surface where it may be damaged.
Figure 15 - Interconnect Cable Pinout - Connector at End of Cable