9600 Service Manual - gmecorp-usa.com

18 Generator Calibration
MERGE EXISTING DATA FILES
1. From the Calibration Menu, select I - Return To Main Menu And Merge Existing
Data Files.
NOTE: Option “H” is not for service use. Skip this option.
2. The message "Merging files, recreated All.Dat" will be displayed followed by a
message stating that the "EEPROM. Dat file has been updated". The software then
returns you to the Mainframe Menu.
BACKUP GENERATOR SOFTWARE
NOTE: Do not reboot the system from the Mobile C-Arm Menu or cycle power to reboot the
system until the generator software has been backed up. Rebooting the system at
this time affects the “Hot Byte” as explained in the “C-Arm Software” section of this
manual.
1. Remove the SRAM card from the Technique Processor PCB and power off the
system.
2. Locate the generator software backup disk (3 1/2-inch HD floppy located on the C-
Arm in an anti-static bag).
3. Make two 3 1/2-inch floppy backup copies of the C-Arm disk per the procedure in
the C-Arm Software section of this manual. Return one backup diskette to the C-
Arm and return the other to the Technical Support Office for evaluation and
archiving.
4. Reinstall the SRAM card in the Technique Processor and remove the cables from
the Analog Interface PCB.
5. Power on the system. Confirm operation.