9600 Service Manual - gmecorp-usa.com

Power Distribution 3
WORKSTATION CIRCUIT BREAKERS
CB1 A 10 Amp, reset only breaker, on the AC cord assembly. In line with incoming AC
to the Workstation.
CB2 A 10 Amp, reset only breaker, located below the point of connection of the
interconnect cable. In line with AC going to the C-Arm.
CB3 A 5 Amp, reset only breaker, in line with AC to be distributed thru the Workstation.
Located on earlier models on the left side of the Workstation by the Power Control
PCB. Accessed by removing rear panel, left side panel, and protective clear
plastic cover. The location on later models is next to CB2 by the interconnect
cable.
POWER SUPPLY PS1
+12V, -12V, +5V, -5V
LOCATED INSIDE
ELECTRONICS BOX
ON THIS HINGED PANEL
CIRCUIT BREAKER CB3
ON EARLIER MODELS
(WORKSTATION AC) AND
TERMINAL BLOCK TB2
POWER
CONTROL PCB
ISOLATION
TRANSFORMER T1
POWER
SUPPLY PS2 (+24V)
Figure 2 Workstation Power Components
SURGE
SUPPRESSOR
PCB