9600 Service Manual - gmecorp-usa.com

24 Generator Calibration
5R ABS TABLE CONFIGURATION (S/N 69-0001 TO 69-
1160)
NOTE: Confirm your system serial number falls into the above category.
To configure the correct ABS table, use the following procedure:
1. Power on the system and allow it to boot completely.
2. Insert the diagnostic disk (00-876781-01) in the rear of the Workstation.
3. Press the SETUP OPTIONS key on the Workstation.
4. Select Access Level 2, then Access Mainframe Menu.
5. Select option "J" ABS Index File Editor.
6. Select option "A" Edit ABS Index File. The following table should appear:
ABS INDEX TABLE EDITOR
Rec Description ABS Display Name Boost In Use Boot PLS VLI P VLI
Nos
Avail
Up Rate Ofst Ofset
1 Standard for Domestic
5R
Standard 5R/Min Yes Yes Yes 4 0 0
2 Low Dose for Domestic Low Dose Yes 1 0 0
3 Chest 5R Chest 5R/Min Yes Yes 4 -100 -70
4 Extremities 5R Extremities 5R/Min Yes Yes 4 50 35
5 Standard 10R Standard Yes 4 0 0
6 Chest 10R Chest Yes 4 -100 -70
7 Extremities 10R Extremities Yes 4 50 35
A. Page Up B. Page Down C. Top of Table D. End of Table
E. Select Record F. Edit in Use G. Edit Boot Up
Default
H. Edit Pulse Rate
I. Edit VLI Ofst J. Edit Pulse VLI Ofst
- Exit
Enter command
letter:
NOTE: Do not change the PLS Rate, VLI Ofst, or the P VLI Ofset settings.
7. (a) If your screen matches that the one shown above, no changes are necessary.
Press ESC twice, then select A to return the system to normal. Press ESC twice
again to clear the right monitor.
(b) If your screen does not match the screen shown above, select option "E - Select
Record" to configure the system. Follow screen instructions to save these changes.
8. This completes this procedure.