9600 Service Manual - gmecorp-usa.com

30 Mechanical Assemblies
BALANCE WHEEL REMOVAL
WARNING... Electrical circuits inside the equipment use voltages that are capable
of causing serious injury or death from electrical shock. Use
appropriate precautions.
1. Verify that the Workstation keyswitch is turned to the OFF position and the
AC power plug is disconnected from the wall receptacle.
2. Remove the Rear Handle Cover Assembly by removing 3 screws located
behind the assembly door and one screw on each side.
3. Remove the Front Cover by removing 2 screws near the top of the vertical shaft.
4. Remove the Right Front Cover by removing the 3 screws securing the cover
to the Mobile C-Arm.
5. Turn circuit breaker CB1 to the OFF position.
Figure 14 - Balance Wheel Removal
6. Cut the cable tie that secures the wiring near CB1 and unplug the battery
connectors.
WARNING... The batteries are capable of delivering high currents at high voltages
and should be considered fully charged at all times. Remove jewelry
such as rings and watches when working around dangerous
voltages.
7. Remove the spacer from the top of the right battery pack.
8. Lift the battery pack straight up and then pull the pack straight out.
9. Elevate the Mobile C-Arm approximately 4 inches from the floor.
10. Remove the bolt (axle) and balance wheel.