9600 Service Manual - gmecorp-usa.com

Event Codes & Messages (Cont.)
57 WARNING, HIGH KV E, N kV detected higher than allowed range
for desired technique.
58 WARNING, LOW KV E, N kV detected lower than allowed range for
desired technique.
59 WAIT N/A Message only, displayed alternately with
WILL OVERHEAT
5A ?? PCT CHARGE E Used as a message with battery charge
state, 50 or 70 percent.
5B STANDARD 5R/MIN N/A Message only, ABS table display name
5C LOW DOSE N/A Message only, ABS table display name
5D CHEST 5R/MIN N/A Message only, ABS table display name
5E EXTREMITIES 5R/MIN N/A Message only, ABS table display name
5F STANDARD N/A Message only, ABS table display name
60 CHEST N/A Message only, ABS table display name
61 EXTREMITIES N/A Message only, ABS table display name
62 N/A N/A
63 CHECKSUM ERROR N/A Message only. During boot, a checksum
routine is run on the MAIN software. If
checksum is in error this message will be
displayed.
64 BOOT-UP TERMINATED N/A Message only. Displayed after
CHECKSUM ERROR (see above).