9600 Service Manual - gmecorp-usa.com

C-Arm Software 5
X-RAY CONTROL PANEL
FLUORESCENT DISPLAY
TECHNIQUE
PROCESSOR HEX
DISPLAYS
U2 U1
(MSB) (LSB)
CORRESPONDING SYSTEM
ACTIVITY
3 1 Initializing Option EEPROM (U15) on
Technique Processor PCB.
F F Load software from SRAM to
Technique Processor PCB RAM
memory (U16-U19).
0 0 All previous steps completed.
0 0 EVENT.EXE loaded and starting
initialization.
0 0 Data from Option EEPROM (U15) on
Technique Processor PCB read into
local table. Event buffer initialized.
0 0 Option EEPROM (U15) on Technique
Processor PCB and EEPROM.DAT file
brought into synchronization.
0 0 EVENT boot process complete.
0 0 MAINMENU loaded.
0 0 Check for OEC access disk if
necessary. If needed and not found,
“OEC Boot Disk Needed” will be
displayed.
0 0 OPTIONS.DAT file on SRAM card
successfully found and ABS index file
is OK.
0 0 Workstation returned to normal mode
and loading Main Application.
0 0 Main application loaded. Auxiliary port
initialized. System buffers cleared.
Error handler set up. Event code file
opened.
0 0 OPTIONS.DAT file opened and read
into memory.
0 0 Appropriate MAP file opened and
loaded into control panel map.
0 0 Message file MAIN.TXT opened and
messages loaded into message table.
Timer interrupt vector set.
Control break turned off.
0 0 Initialize variables. Read command line
parameters & Set software switches.
0 0 Clock on Analog Interface PCB started
and PIO’s reset.