9600 Service Manual - gmecorp-usa.com

Event Codes & Messages (Cont.)
0C AD CHANNEL-0
FAILED
0D AD CHANNEL-1
FAILED
E, F kVp detected during boot-up without Xray
command initiated. Refer to
C-Arm Control and kV Generation
sections.
E, F mA detected during boot-up without X-ray
command initiated. Refer to
C-Arm Control and mA Generation
sections.
0E AD CHANNEL-8 FAILED E, F Voltage sensed on redundant kV sense
circuitry in HV tank during boot-up. Refer
to C-Arm Control and
0F AD CHANNEL-11
FAILED
kV Generation sections.
E, F To much current sensed from
Battery Charger PCB during boot-up.
Refer to C-Arm Control and
Power Distribution sections.
10 MAIN.TXT E, F Error reading MAIN.TXT file from
SRAM card during boot-up.
11 FLUORO - XRAY E Indicates last function performed
12 PRESS ANY KEY N Message only.
13 FLUORO - XOFF E Indicates end of fluoro exposure.
14 FLUORO - DIAG N/A Not used.
15 FLUORO BOOST E Indicates fluoro exposure in boost mode.
16 FLUOROX - FILM E Operator initiated transition; fluoro to film