9600 Service Manual - gmecorp-usa.com

C-Arm Software 17
COPY FILES FROM SRAM TO 3 1/2-INCH FLOPPY DISK
Whenever a generator calibration is performed (see Generator Calibration section in
this manual), the new calibration data must be copied from the SRAM card on the
Technique Processor PCB to the 3 1/2” backup disk. This preserves the calibration data
in the event of an SRAM card failure.
Equipment required:
• Computer with PCMCIA port
• Software (loaded on computer) to recognize PCMCIA port
(OEC P/N 00-900876-01)
• Generator backup software (3 1/2-inch disk)
1. Boot computer, insuring that the PCMCIA port is recognized by software.
2. Install SRAM card from Technique Processor PCB in PCMCIA port on computer,
listen for beep from computer that indicates recognition of card.
3. Install 3 1/2-inch floppy backup disk on computer.
4. Use the following command to copy the files from the SRAM card to the floppy disk:
copy F:*.* A:
NOTE: Assuming F drive as the PCMCIA port and A drive as the 3 1/2-inch floppy drive.