9600 Service Manual - gmecorp-usa.com

Image System 47
NOTE: H.V. cables entering the C-arm turn immediately and are routed to the X-ray
Tube. The cables can't be removed without pulling the cables out the II end
of the C-arm first.
15. Once the cable connectors have been pulled out of the II end of the C-arm, remove
the strain relief and pull the cables out one at a time.
16. Remove the Front Cover (2 Torx screws) and the Right Front Cover (3 Torx) and
then remove 2 screws securing the C-clamp strain relief.
17. Remove the High Voltage Cable ground wires from the chassis and remove the
A1J3 connector from the Motherboard PCB.
18. Remove the Left Front Cover and disconnect the A4J5 connector from the Power
Motor Relay PCB.
19. Disconnect the High Voltage connectors from the High Voltage Tank using the
spanner wrench.
20. To route the High Voltage Cable through the hole in the Right Front Cover
disassemble the candlestick cable nut assembly and pull the cables and
connectors.