9600 Service Manual - gmecorp-usa.com

C-Arm Software 7
MAINFRAME MENU
The Mainframe Menu (Error Section) is accessed using the Workstation. The
Workstation is used as a terminal since the generator assembly does not have its own
direct serial link for using this program. This service software contains several options
which are explained in the next few pages. Perform the following steps to access this
generator service software.
ACCESSING THE MAINFRAME MENU
1. With the system powered on, insert the OEC access disk into the floppy drive at
the rear of the Workstation.
2. Press the SETUP OPTIONS key on the Workstation.
3. Use the cursor control keys (or trackpad) to highlight the Access Level 2 (Service)
sub-menu and press ENTER (or superkey).
4. Select Access Mainframe Menu. When this option is selected, the following menu
appears on the left monitor.
****** MAINFRAME MENU ******
A. Run Applications (Take X-rays)
B. Run Applications with Parameters
C. Run Calibration
D. System Configuration
E. mA Limit File Editor
F. Examine Event File
G. Run Status
H. Collimator Calibration (System will reboot)
I. Language Options
J. ABS Index File Editor
- Return to DOS
Enter command letter:
NOTE: When this service software is activated, the generator interlocks are broken in order
to prevent X-rays.