Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

• Time interval to update the Date and Time on access points. Time interval between two subsequent periodic updates of date and time,where the periodic sending function is enabled.• Address for sending the System Code to the access points. Viewing and setting of the group addresses to which the system code mustbe sent. Possibility to create a new system code or to send the bus the previous code sent to the bus.System devices date updateAfter putting the system in service you'll need to set the date on all devices that use it for their proper functioning.The transponder readers are definitely among the devices of the Well-Contact system using such information. Without such information, in fact, accessmanagement cannot be done properly.In addition to the required "initial setting" of the date on all devices that use it, to ensure a good synchronization between all devices in the system, werecommend enabling the periodic sending.In fact, you may experience malfunctions due to possible drifts in the time measurement of the various devices in the system.From the perspective of the ETS configuration, a global group address (single group address associated with propertyID 19 of all transponders (readersand pockets)) will have to be dedicated to sending this data to all the devices that need it.Setting of the address for sending the Date to the access pointsTo set the address to use for the system date update, proceed as follows:1. Left-click the button to select the address, as shown in the picture (it's the “…” button highlighted in yellow):47