Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

5. After defining the basic data of the functions master, you must proceed with the association of the functions master with all the thermostatsyou want to be part of it.This is accomplished with the so-called drag & drop (typical of Windows applications).Specifically, to associate a thermostat to a functions master, follow these steps:a. In the section "DEVICES" of the "ETS Configuration" window, locate the thermostat you want to associate with the functions master.If the desired thermostat is not visible because the lower level of the "thermostat" device is not expanded, expand the sub-levelof the "thermostat" device pressing the '+' symbol related to the "thermostat" device (or "double clicking" the row corresponding tothe "thermostat" device).b. Left-click the desired thermostat (in the "DEVICES" section) and, holding down the mouse button, "drag" it to overlay the row correspondingto the desired functions master (in the "ENVIRONMENTS" section). A yellow arrow appears on the left of the name ofthe functions master and close to the cursor icon the symbol '+' appears.See the following picture.Release the left button of the mouse at the desired functions master.The name of the associated thermostat will appear under the name of the functions master, as shown in the picture below.c. Repeat steps a. and b. (described above) for all the thermostats that you want to associate with the functions master.In the following picture, for example, the functions master "North side rooms thermostats" have been associated with the followingthermostats: "Thermostat room A" and "Thermostat room B".96