Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

3. Drag the address associated with the command you want to send through the scenario from the "ADDRESSES/OBJECTS section" to the"actions list section".If the desired address is not visible, expand the appropriate levels of the tree to make the desired address selectable.After "dragging" the address, the configuration window will look as shown in the following picture.4. Set the command parameters associated with inserted address:a. Command. It is the command you want to run on the device identified by the address. The commands available for the specificaddress type can be selected from a menu, as shown in the picture below.b. Value. Represents the value to be assigned to the address of the command you want to perform.For some types of addresses the value is implicit in the choice of the command and, consequently, the "Value" field is not editable.For others, you can enter the value the address should take (such as setting the setpoint of a thermostat).c. Timing. You can define, for each command executed by the scenario, a delay between the time of execution of the scenario andthe sending of the specific command.This feature was implemented to try and solve some problems that may occur and that depend on the specific characteristics ofthe devices, or to create special effects in the command sequence.Here are some examples where you may find convenient to use the field Timing:129