Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

Periodic sending of date and time to the system devicesAs mentioned earlier, for the proper functioning of the automation system (in particular the access control system), we recommend that you enable theperiodic updating of date and time provided by Well-Contact Suite software.To enable this feature, left-click the field "Periodically send time and date to access points", as shown in the picture.If Periodically send time and date to access points" is enabled, the field to set the time interval for updating date and time is enabled as well.This interval can be set with a one hour range.Setting the transponder readers' System CodeAfter putting the system in service you'll need to set the System Code on all the transponder readers.The system code is a number that identifies the specific system, to prevent the cards programmed and activated on a Well-Contact system frombeing used to access different areas of a different Well-Contact systemThrough the "Generate New System Code" button, described in the next few chapters, the Well-Contact Suite software creates a new system code andsends it to the devices that need it (via the KN busIMPORTANT:This procedure disables all cards created with a previous system code. You will then need to recreate all the cards which areactive at that time. To do this use the "Replace Card" procedure.You can also send the system code previously created (and sent) to the system, without disabling the cards which are active at that time. This is useful ifyou need to send the system code to a device that has been replaced.IMPORTANT:The replacement of a transponder reader makes it necessary to send System Date, Time, Code to the bus. Any cards which gave access to areader before its replacement must be re-created (including any staff cards). To do this use the "Replace Card" procedure.From the perspective of the ETS configuration, a global group address (single group address associated with propertyID 21 of all transponders (readersand pockets)) will have to be dedicated to sending this data to all the devices that need it.To set the address to use for the system code, proceed as follows:1. Left-click the button to select the address, as shown in the picture (it's the “…” button highlighted in yellow):52