Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

It is a table whose rows include the addresses/objects of the system that was configured on the Well-Contact Suite software.The columns display the parameters of the addresses/objects in question. Some parameters, besides being shown, can also be changed as describedbelow.Here follows the description of the parameters included in the columns of the Address/Object Configuration table:• Name. It is the description that has been allocated to an address or a set of addresses (with the same features) via ETS3 during the creation ofthe ETS project. It cannot be changed.• Method(s). It is the description of the commands that can be sent to the bus for that type of addresses. It cannot be changed.• Status. It views the possible status that the address/object can have. It cannot be changed.• Data Format. It is the type of KNX EIS data for the address/object. It cannot be changed.• Default. If this field is active, it means that type of address is assigned by default by the Well-Contact Suite software for that specific type ofKNX EIS. If it's inactive it means that's not the default type (for the Well-Contact software) for the addresses of that type of EIS. It cannot bechanged.• Displayed. By enabling this field, all addresses of the same type as the one selected will be displayed (using the images of the "Image On" and"Image Off" fields) in the representation of environments that contain them, within the supervision section of the Well-Contact Suite software.By disabling this field, the addresses of the selected type won't be displayed.Remember, however, as already mentioned, that these settings can be changed in a "timely" way within the specific environments, asdescribed below.• Image On. It is the image you want displayed to represent the selected address when the status is "ON" (Active, On…). By selecting this fieldthe dialog to select the image shall be displayed, as shown in the picture below.186