Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

Viewing the characteristics of the environmentsSelecting the row corresponding to an environment, in the "Selected Environment Detail" section you'll see the descriptive data that characterize it.With reference to the previous picture, below are described the fields in the "Selected Environment Detail" section:• Selected Environment The name given to the environment in the ETS project.• Environment Type Classification of the selected environment's typology. Assigning the environment's typology is essential for the Well-Contact Suite software to properly manage the environment itself (in the chapter Editing environment data the use of the environments'classification is described in detail).• Environment number. Typically this field is used to assign the room number in a hotel. The management of rooms reservations (i.e.environments whose type has been defined as "rooms") and related management of the creation of entry passes, requires the "EnvironmentNumber" to be entered for the environments such as "room" is plugged in• Describing the environment. It is an alphanumeric string that can be used (optionally) to identify an environment, which is displayed in thesupervision windows.This field can be used, for example, when the rooms of a structure are also identified by a name such as, for example, "Blue Room".IMPORTANT: For the rooms, the description string is not a substitute for the room number, which must be defined in any case.Creating EnvironmentsAs already mentioned above, if all the information on the topological structure of the automation system (representation of the system in terms of buildings,floors, rooms,…) has already been input in the ETS project, the Well-Contact Suite Software can import all such information.Similarly to what was said earlier in the chapter The "ZONES" section, as regards the creation of elements of the ZONE type in the representation of thetopological structure of the system, it is also possible to create elements of the ENVIRONMENT type (rooms, common areas, technical areas), placing themin the existing structure.After creating a new environment in the ENVIRONMENT section you can insert it in one of the zones in the ZONES section, as described in Inserting anenvironment in a zone.To create a new environment, proceed as follows:1. Right-click an environment in the ENVIRONMENT section. A menu appears.1. 2. Select "New Environment", as shown in the picture below.3. The following dialog, where the name of the environment must be entered (NOTE: the name of the environment cannot be equal to an existingone)90