Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

Addresses/Objects ConfigurationAs mentioned in the chapters describing the ENVIRONMENTS section, the Well-Contact Suite software displays an icon next to each address/objectimported from the configuration files exported from ETS.The icons used are shown in the table below and describe the current configuration status of the addresses/objects in question.Graphical symbolMeaningAll the information about the address/object required by the Well-Contact Suite software have been entered correctly.The information about the address/object is incomplete and the Well-Contact Suite software may not properly handle thesupervision of such addresses/objects, because, in absence of the necessary information, some default data is automaticallyassigned.The symbol in question requires the verification of the type assigned automatically.To enter the necessary information to the Well-Contact software suite for proper handling of addresses/objects, follow these steps:1. Select the address/object from the tree of the addresses in the ADDRESSES/OBJECTS section, right-clicking the representation of theaddress/object itself.NOTE: If you need to set the same configuration data for a number of addresses/objects, you can multi-select them.The multi-selection follows the standard rules for the selection of items from a list typical of most commercial software:Use the CTRL key: holding down the CTRL key (on the keyboard) you can add or remove (toggle) the item on which you're pressing the leftmouse button.Using the SHIFT key: left-clicking an item on the list and then, after pressing and holding the SHIFT key (on the keyboard), left-clicking anotheritem on the list, all the elements between the two extremes will be selected.2. The "Selected Address/Object Details " section displays the information regarding the address/object configuration.The data displayed are:a. Selected Address It is the name assigned to the address by ETS. The name cannot be modified by the Well-Contact Suitesoftware, then you should assign a name that makes the functionality of the address easily identifiable through ETS, in order toavoid system failures caused by incorrect interpretation of the functionality provided by the addresses/objects.106