Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

As mentioned previously, the windows for sending commands to functions masters contain input fields required for the actual deviceswindows, but do not contain fields designed to display the status.Consequently, for the description of the command fields of this window, refer to the thermostat one, as described in detail in the chapterThe thermostat setting window of the Well-Contact system.The first time you open the command window of a functions master of a thermostat, or at least if no changes were carried out and thensaved. the numeric fields contain default values.Below is the description of the buttons at the bottom of the window:a. "Undo Operation" button This button exits the functions master control window without sending or saving any changes made onthe same fields.b. The "Save" button This button allows you to save all settings data of the current functions master. This command can be usefulin the following two cases:• You want to save your settings so you can later send them to the real thermostats associated with them.• You want to save the new settings so they can be used as the default for the real thermostats associated with them, that havebeen assigned that functions master as "default".c. The "Run" button. This button allows you to send to the real thermostats the settings made or at least the settings currently displayedin the functions master window.IMPORTANT. Please note the following very important notes.• Pressing the "Run" button ALL the commands in the setup window of the master are sent to the associated (and activated)thermostats.The commands are sent to thermostats at real time intervals (using the settings in the window for the creation and configurationof the master).If you have associated many thermostats with the functions master, it can take several minutes for all commands to be sent to allassociated (and activated) thermostats.If you try to run a functions master's commands while running a previous functions master, the following message appears:In this case, you'll have to wait before sending a subsequent command to the master.• In order for the commands to be sent from the functions master to a real thermostat associated, it is necessary that "Enablethermostat management through associated masters" is enabled the real thermostat's window.Otherwise, even if that real thermostat has been associated with a functions master during its creation and configuration,when you press the "Run" button from the window of the associated functions master, no command will be sent to that realthermostat.• A real thermostat can be associated, as for commanding, to multiple functions master.• A real thermostat can be associated with A SINGLE functions master to restore the default data.3. Making the desired commands.98