Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

The display area of ​the state of operation of the software componentsAs mentioned above, the area below the Well-Contact Software Suite window contains all the indicators about the operational status of the software.This area will later be referred to as "status bar" (of the software).The status bar of the software is visible in all the operational sections of the software, except during the "ETS Configuration" procedure.The status bar, starting from the left, contains the following indicators:• Indicator of the status of communication between the software that manages the user interface and the part that deals with themanagement of services.This indicator may take the following status:Icon Status DescriptionOK ConnectionConnection ProblemsThe communication between the "server" and the "client" is taking place properly.Communication problems between the "server" and the "client".• Indicator of the status of communication with the database.This indicator may take the following status:Icon Status DescriptionOK ConnectionThe communication with the database is taking place properly.Connection ProblemsCommunication problems with the database.• Indicator of the status of the capability of writing access cards.This indicator may take the following status:Icon Status DescriptionCards writing feature OKCards writing featurepartialCards writing featureinactiveThe card programmer's management is taking place properly.The software communicates with the software modules that manage the programmer but they do not communicatewith the programmer.The card programmer's management is inactive.• Displaying of the last telegram received from the KNX bus..With this indicator you can see the content of the last telegram sent from the KNX bus and received by the Well-Contact Suite software.This view is optional and can be enabled or disabled by configuration menu if you have the required privileges to access this section of theconfiguration menu (Settings -> Global Configuration Settings; "General" tab; "View the bus telegrams on the Status Bar" field)This feature is especially useful during the installation and configuration of the system to verify the receipt of telegrams from the KNX bus.Left-clicking the area where the last telegram received by the software is displayed, a window appears with a list that represents the history ofthe receipt of telegrams from the bus and received by the Well-Contact Suite software (to access this list you must have enabled the view ofthe last telegram received from the KNX bus).The following picture shows the "Bus Monitor" list.15