Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

• You want to create a scenario that controls a set of electrical loads characterized by high tension The contemporary (ornear-contemporary) operation of the loads could trigger the overload protection.• You want to create a scenario that controls a set of KNX devices that respond to the command by sending a telegramto the KNX bus. Sending simultaneous (or nearly) commands to the devices may generate high traffic on the KNX bus.• You want to create a scenario where sending commands to the devices must comply with certain deadlines to createspecial stage effects.5. Repeat steps 3. and 4. For all the commands you want to include in the scenario.After completing the configuration, the window to configure the scenarios will look as shown in the picture below.You can delete a command embedded in the scenario: select the corresponding row and press the button "Delete", as described in thefollowing picture.You can change the order of execution of the commands: select the row corresponding to the command you want to move up (or down)compared to its predecessor (or its successor) and press the button "Move up" (or move down), as described in the following picture.130