Software Well-Contact Suite Office Linee guida ed ... - Vimar S.p.A.

ETS ConfigurationIntroductionTo be able to supervise the automation system through the Well-Contact Suite software, you must provide the software with the data referred to systemitself and related configurations.The configuration of the KNX automation system is accomplished through the KNX ETS3 software, the standard software tool for configuring the systembased on KNX standards.To interact with the KNX automation system the Well-Contact Suite software needs to know the information needed to define the configuration of individualdevices that make up the system and the relationship between the various devices.The Well-Contact Suite software is able to import the files containing information about the system configuration, exported from ETS itself.In addition to the information regarding the configuration of KNX devices and the relationship between the various devices, the Well-Contact Suite softwarerequires information about the topology of the system in order to give a representation of the system which facilitates the supervision by the user.In other words, in addition to the device configuration, you must enter the information regarding the structure of the system from the topological point ofview: division into buildings, environments (rooms, common areas, technical areas), control panels.A good ETS project, usually includes much of this information already. In this regard, some guidelines to follow during the creation of an ETS project areprovided, so that the software can learn as much information as possible from the ETS project, making the subsequent part of the Well-Contact Suite softwareconfiguration faster and simpler.In any event, even if the ETS project did not contain information related to topology, you could enter it during the next phase of the Well-Contact Suitesoftware configuration, as will be described in the next few chapters.In the section "ETS Configuration" you can perform configuration tasks that enable the Well-Contact Suite software to interact with the KNX automationsystem.To access the "ETS Configuration" section use the menu "Settings" as shown in the picture.Unless all the KNX system configuration data has been imported, every time you log in to the "ETS Configuration" section, the following window willappear, warning the user that the configuration data of the automation system has not been imported yet.70