iCys User Guide

Installing iCys Research Imaging Cytometer General Installation Information
General Installation Information
Installing iCys Research Imaging Cytometer requires the following:
❑ Sufficient space to accommodate the physical iCys equipment
❑ Proper electrical power configuration and receptacles
❑ Acceptable environmental conditions
Note: iCys needs a vibration-free bench top. (Shock mounting is not required.)
Unpacking the iCys System
The iCys should be unpacked and installed only by a representative from CompuCyte
or an authorized agent. If the system is to be stored temporarily before installation, it
should be in a secure, heated, and dry area.
Upon receipt of the iCys, examine the shipping materials for exterior damage or
evidence of mishandling. If they appear damaged, notify the carrier and CompuCyte
or an authorized agent and request an inspection from the carrier.
Following initial installation, a representative from CompuCyte Corporation or an
authorized agent will instruct designated personnel on the basic operation and care of
the iCys.
Physical Space Requirements
The following table specifies the iCys’s space requirements:
Table A-1: iCys Physical Space Requirements
Analysis Unit ❑ Width 44 in. (112 cm)
❑ Depth 32 in. (82 cm)
❑ Height 31 in. (79 cm)
To allow for servicing, the space above the table surface
should be at least 44 inches or (112 cm)
❑ Weight 275 lbs. (125 kg.)
Computer ❑ Width 8 in. (21 cm)
❑ Depth 19 in. (49 cm)
❑ Height 17 in. (44 cm)
Monitor ❑ 20” Flat panel display monitor
20” (51cm) wide, 12” (31cm) depth, 20” (51cm) height
❑ Dual monitors are optional
Autofocus
monitor (if
installed)
❑ Width 9 in. (23 cm)
❑ Depth 10 in. (26 cm)
❑ Height 9 in. (23 cm)
A-2 iCys Research Imaging Cytometer User Guide Revision B