iCys User Guide

iCys Cytometric Analysis Software Application Overview iCys Task Bar
4. Click on the “-” symbol next to each of the headings to contract it. Clicking on
the “+” symbol next to the headings will expand them and display all the
options under that heading.
Tip: Right-clicking on the left hand portion of the page will allow you to
expand or contract all headings at once.
Adding Modules
To add a module to the protocol, click on the module in the tool box menu, then
click on the center portion of the window. The module you have selected will
appear.
A dialog box for that module will appear in the right-hand pane of the window.
Each type of module will have a different type of dialog box. Protocol modules
are described below.
Deleting Modules
To delete a module, right-click on the module, and select “Delete Module.”
Disabling / Enabling Modules
To disable a module right-click on the module, and select “Disable Module.”
Note: Selecting “Disable Module” will also disable any modules connected
through the output node of the disabled module. To enable a disabled
module, right-click on the module and select “Enable Module.” This will
also enable any modules connected through the output node of that
module.
Select All
Selects all modules in the center portion of the Protocol window. Right-clicking
again on any of the modules allows one to “Delete Modules” (deletes all
modules).
Copy
Not implemented
Print
Not implemented
Protocol Modules
iCys contains several types of modules. These are used as building blocks for
protocols. These modules are described below.
3-36 iCys Research Imaging Cytometer User Guide Revision B