iCys User Guide

Using the iNovator Toolkit iNovator-specific Protocol Modules
Operation
Arithmetic operators
❍ Create new image—If Create new image is selected, a new image is created
and the original input images are left intact.
❍ Modify input image—If Modify input image is selected, the input image is
updated with the new image data.
Add and Subtract Modules
The Add and Subtract modules perform these operations on two input images to
generate a third image. The resultant image is constructed by either adding or
subtracting the values of each of the corresponding pixel values from the input
images. In the case of the Subtract module the right image is subtracted from the left
image. A protocol using the add module is shown below.
The Add and Subtract modules can be "nested" as shown below.
B-20 iCys Research Imaging Cytometer User Guide Revision B