B - Ardiehl.de

PEDAL INTERLOCK LINKAGE
Removal and Installation
Raise the lift arms and install an approved lift arm support
device. (See Page 1–1.)
Raise the operator cab. (See Page 1–1.)
Remove the interlock shield mounting nuts (Item 1) [A].
Installation: Tighten the shield mounting nuts to 25–28
ft.–lbs. (34–38 Nm) torque.
Remove the interlock shield (Item 2) [A].
Remove the interlock mounting nuts and plastic washers
from behind the nuts [B].
Remove the interlock (Item 1) [B] and plastic washers
from behind the interlock.
Installation: Hold the inside plastic washer up with an
O–ring pick or a small screwdriver so the plastic washer
does not become wedged between the side panel and the
interlock nut [C].
Installation: Tighten the interlock mounting nuts to
84–95 in.–lbs. (9,5–10,8 Nm) torque.
To install new interlock mounting bolts, remove the top
bolt from the front panel and loosen the two bolts at the
bottom of the panel [D].
A
B
C
D
2
1
P–01216
P–01210
P–01219
P–01213
853, 853H BICS Loader
–2–69– Service Manual
1