B - Ardiehl.de

CAMSHAFT (Cont’d)
Tappets (Cont’d)
Check the diameter of the tappets [A].
Standard – 0.511–0.5114 inch (12,98–12,99 mm)
Limit – 0.510 inch (12,95 mm)
Clearance between tappet and engine block bore as
listed [B].
Standard – 0.0012 inch (0,03 mm)
Limit – 0.0039 inch (0,09 mm)
Tappet Installation
Lubricate the tappets before installation.
Lubricate the camshaft bearings and journals. Install the
camshaft, carefully not to damage the bearings.
Install the camshaft gear. (See Page 7–74.)
Check the camshaft end play using a feeler gauge [C].
Standard – 0.0002–0.0045 inch (0,05–0,114 mm)
Limit – 0.0079 inch (0,2 mm)
After the rocker arm assembly is installed, make sure to
set the valve clearance. (See Page 7–38.)
–7–78–
A
B
C
B–08211
B–08212
B–08216
853, 853H BICS Loader
Service Manual