B - Ardiehl.de

BLOWER HOUSING/FAN GEARBOX
Removal and Installation
Raise the lift arms and install an approved lift arm support
device. (See Page 1–1.)
Raise the operator cab. (See Page 1–1.)
Remove the mounting bolts (Item 1) [A] from the gas
cylinder mounting bracket.
Installation: Tighten the mounting bolts to 80–90 in.–lbs.
(9–10 Nm) torque.
Remove the hydraulic fluid reservoir. (See Page 2–1.)
Disconnect the wiring harness connectors (Item 1) [B].
Remove the harness clamp (Item 2) [B].
Disconnect the breather hose from the fan drive housing.
Lay the electrical harness down for clearance at the
blower housing.
Remove the clamp and belt shield (Item 1) [C] for the fan
drive.
Remove the fan drive belt.
Installation: When checking the fan gearbox oil level,
make sure the level does not go above the top of the shaft
in the gearbox [C]. Use 90W gear lube oil if the level is low.
Use a putty knife to remove the sealant from the blower
housing and loader frame [D].
Revised June 97
–7–10–
A
B
C
D
2
Oil Level
1
1
CD–15015
P–04860
1
P–04863
P–04862
853, 853H BICS Loader
Service Manual