B - Ardiehl.de

HYDROSTATIC PUMP (Cont’d)
853, 853H BICS Service Manual #6724012 – Hydrostatic System Section Part 2 of 3
Assembly (Cont’d)
Install a new gasket. Install the end cap over the centering
screw. Turn the end cap up to the housing [A].
Install the five bolts into the end cap [B].
Tighten the bolts to 10–13 ft.–lbs. (14–18 Nm) torque.
Center the piston using the measurement recorded
during disassembly [C].
NOTE: The approximate distance between the
piston and housing edge is 0.5 inch (12,7
mm). Any measured adjustment is
approximate. The final neutral adjustment
must be performed with the pump installed
and engine running.
While holding the centering screw stationary, install the
neutral adjustment lock nut [D].
Revised June 96
–3–50–
A
B
C
D
CD–00084
CD–00081
CD–00080
CD–00079
853, 853H BICS Loader
Service Manual