B - Ardiehl.de

SEAT BAR (Cont’d)
Removal and Installation (Cont’d)
Disconnect the seat bar sensor connector (Item 1) [A].
Remove the seat bar mounting bolt (Item 1) [B] (both
sides).
Installation: Tighten the seat bar mounting bolts to
25–28 ft.–lbs. (34–38 Nm) torque.
Remove the seat bar sensor mounting bolt (Item 2) [B]
and nut.
Installation: Tighten the sensor mounting bolt to 80–90
in.–lbs. (9–10 Nm) torque.
Remove the sensor assembly from the magnetic bushing
on the seat bar.
Installation: Be sure the two tabs on the pivot bushing
are located in the slot on the cab as shown [C].
Pull both ends of the seat bar which are mounted to the
operator cab, back from the mounting positions on the
operator cab [D].
Remove the magnetic bushing mounting bolt, washer,
magnetic bushing, plastic bushing and pivot bushing from
the seat bar [D]. Refer to Page 8–1 for correct assembly
procedure of the seat bar sensor assembly.
Remove the mounting bolt, gas cylinder mounting
bracket, plastic bushing and pivot bushing from the seat
bar [D]. Refer to Page 5–3 for correct assembly
procedure of the gas cylinder mounting assembly.
–5–4–
A
B
C
D
P–03982
1
2
1
1
P–03981
P–03246
P–03247
P–03983
853, 853H BICS Loader
Service Manual