B - Ardiehl.de

STEERING LEVERS (Cont’d)
Adjusting the Wheel RPM Left Compared to Right
Side
NOTE: This procedure is for MINOR adjustment in
full forward travel only. Steering neutral
setting must be correctly adjusted before
this procedure.
1. Loosen the bolts at the stop (Item 1) [A] and lower
the lever stops (both sides).
2. Start the engine.
Put jackstands under the front axles and rear
corners of the frame before running the engine
for service. Failure to use jackstands can allow
the machine to fall or move and cause injury or
death.
W–2017–0286
3. Check wheel RPM left and right side [B]. They
should be the same. If not, the stop (Item 1) [A] can
be used for MINOR adjustment. Bring the stop up
on the faster side until RPM is equal. (Tighten stop
before re–checking) tighten remaining side in down
position.
Revised June 96
–3–14–
A
B
1
P–02875
P–07959
853, 853H BICS Loader
Service Manual