B - Ardiehl.de

HYDROSTATIC PUMP (Cont’d)
Hydrostatic Pump Neutral Adjustment (Cont’d)
3. Clamp the control lever to the neutral adjustment
bracket with a small locking pliers [A].
4. Start the engine. With the engine running at full
RPM, move the control lever forward until the
wheels just begin to move. Mark the position on the
bracket (felt tip pen) [B].
5. Move the control lever in reverse until the wheels
just begin to move. Mark this position.
6. Stop the engine.
7. Position the neutral adjustment bracket between
the two marks and tighten the holddown bolt [C].
Remove the locking pliers. Start the engine and
check in both directions to be sure the pump will
return to neutral.
8. Remove the socket from blocking the neutral spring
bracket [D].
9. Adjust the steering neutral setting. (See Page
3–12.)
A
B
C
D
P–07929
P–07930
P–07931
P–02866
853, 853H BICS Loader
–3–61– Service Manual