B - Ardiehl.de

SEAT BAR (Cont’d)
Removal and Installation (Cont’d)
To remove the seat bar from the operator cab, the seat bar
needs to be put in the correct location.
Use the squares in the right side of the operator cab side
screen to locate the seat bar correctly [A].
Put the padded corner of the seat bar five squares back
from the front of the operator cab side screen and four
squares up from the bottom of the screen [A].
The arm of the seat bar (Item 1) [B] should also be located
outside of the operator cab, just below the bottom edge
of the cab.
Grab both ends of the seat bar as shown and pull the left
side of the seat bar out of the operator cab until the seat
bar is free [B].
Remove the seat bar from the operator cab.
Reverse removal procedure to install the seat bar.
See the following assembly procedure when installing the
seat bar.
Assembly
Assemble the parts as shown for the left side of the seat
bar pivot assembly [C]:
Mounting Bolt – (Item 1).
Washer – (Item 2).
Keyed Plastic Bushing – (Item 3).
Magnetic Bushing Assembly (Item 4).
Sensor Bracket – (Item 5).
Pivot Bushing – (Item 6).
Mounting Bolt – (Item 7).
Sensor Mounting Bolt (Item 8).
Sensor Mounting Nut (Item 9).
A
B
C
1
7 6 3 2 1
8 5 4
9
P–03984
P–04065
Left Side
of Seat Bar
P–03284
853, 853H BICS Loader
–5–5– Service Manual