B - Ardiehl.de

SEAT SENSOR (Cont’d)
Seat Sensor Test
Use MEL1428 Sensor Tester for the following procedure:
Turn the key to the ON position. DO NOT START THE
ENGINE.
Disconnect the seat sensor connector (Item 1 – Inset)
[A].
Connect MEL1428 Sensor Tester (Item 2) [A] inline as
shown to the seat sensor.
The power light (Item 1) [B] on the sensor tester will
illuminate.
Sit on the operator seat. The sensor test light (Item 1) [C]
should illuminate.
Get off the operator seat. The sensor test light (Item 1) [C]
should go off.
If the above tests fail, there is a problem with the seat
sensor.
Refer to Page 8–14 for the correct procedure to inspect
the Seat Sensor.
Refer to Page 5–1 for seat removal and installation
procedure.
A
B
C
2
1
P–03988
1
1
P–04705
P–04698
P–04699
853,853H BICS Loader
–8–15– Service Manual