B - Ardiehl.de

HYDROSTATIC PUMP (Cont’d)
Assembly (Cont’d)
Install a new gasket and the end cap [A].
Install the five bolts into the end cap [B].
Tighten the bolts to 10–13 ft.–lbs. (14–18 Nm) torque.
Apply oil to the valve plate.
Install the valve plate, bronze side up, into the housing
[C].
The notch (Item 1) [C] in the valve plate must engage the
locating spring pin in the housing.
Apply oil to the needle bearing at the base of the housing.
Apply oil to all parts and surfaces in the rotating group.
Using a snap ring pliers, lower the rotating group into the
housing [D].
A
B
C
D
1
CD–00077
CD–00076
CD–00073
CD–00074
853, 853H BICS Loader
–3–51– Service Manual