B - Ardiehl.de

ENGINE SPEED CONTROL
Removal and Installation
Raise the lift arms. (See Page 1–1.)
Raise the operator cab. (See Page 1–1.)
Remove the two mounting bolts (Item 1) [A] and nuts from
the speed control mounting bracket.
Installation: Tighten the bolts (Item 2) [A] evenly until the
speed control lever moves back and forth at a
comfortable tension.
Pull the speed control away from the loader frame and
disconnect the speed control rod (Item 1) [B] from the
control.
Installation: Be sure to install the control rod in the
bottom hole of the speed control.
Installation: Install the stop bracket (Item 1) [C] in the
same location. It is necessary for the front and rear stop
on the bracket to be located correctly.
Reverse the removal procedure to install the engine
speed control.
Disassembly
Loosen the two control lever mounting bolts and remove
the mounting nuts (Item 2) [C].
Assembly: Do not lubricate the engine speed control.
Replace any worn or damaged parts if necessary.
–7–4–
A
B
C
1
1
1
2
1
2
P–04731
P–04735
P–04068
853, 853H BICS Loader
Service Manual